Of course it could not go so well without trouble.
I have been working on Dagny for three days and boy, have I done a lot! Painting is finished. Well, not counting the touch-ups.. So, as on every work trip, I proceeded to run the engine for ten minutes, just to make sure it works and to move oil around a bit. Well, the starter turns the engine but there is no compression. I tried the hand crank, same issue, the engine turns freely. I checked the decompression lever, but I have never touched it before, since the engine always started right away. The lever feels very loose. Obviously it isn’t doing anything. This is really bad timing, or maybe good timing, depending on how you look at it.. Better now than in the middle of nowhere, but still, very frustrating. Armed with the supreme confidence of the novice in all things diesel, I decided to take the valves cover off. It all looks fine, though I have no idea what fine would be in this case, but there are no bits and pieces floating around at least.
When I turn the hand crank the valves go up and down, good. The decompression lever, used to start the engine by hand, turns a rod on top of the two valves.. Hum.. I can’t see what it is doing exactly. Maybe it is supposed to open some hole in the cylinder head or lift a valve to let air out. Bottom line is, if there is no compression, there is a leak somewhere, otherwise I would not be able to turn the engine by hand. Not that it all matters much anyway, because I doubt I will be able to fix it myself, though I haven’t given up yet. Anyone knows a good looking female diesel mechanic who accepts payments in nature? I thought not.
On the bright side, I will be varnishing today, completing all inside cosmetic work before heading back home. I did hoist the jib just to check everything, missing a couple shackles which I temporarily substituted for zip-ties. I still have to figure out how to rig the self-tacking jib and boom.